MSI 945GT User Guide - Page 47
IDE Primary Master/Slave PIO - + driver
View all MSI 945GT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
BIOS Setup sector read/write. If your IDE hard drive supports block mode (most new drives do), select [Enabled] for automatic detection of the optimal number of block read/writes per sector the drive can support. On-Chip Primary PCI IDE The setting disables/enables the onchip primary PCI IDE interface. IDE Primary Master/Slave PIO The IDE PIO (Programmed Input/Output) fields let you set a PIO mode for the IDE devices that the onboard IDE interface supports. Modes 0 through 4 provide successively increased performance. In [Auto] mode, the system automatically determines the best mode for each device. IDE Primary Master/Slave UDMA Ultra DMA 33/66/100/133 implementation is possible only if your IDE hard drive supports it and the operating environment includes a DMA driver (W indows ME, XP or a third-party IDE bus master driver). If your hard drive and your system software both support Ultra DMA/33, Ultra DMA/66, Ultra DMA/100 and Ultra DMA/133, select [Auto] to enable BIOS support. *** On-Chip Serial ATA Setting *** SATA Mode This setting specifies the SATA controller operation mode. On-Chip Serial ATA This setting specifies the function of the on-chip SATA controller. [Disabled] Disable SATA controller [Auto] Automatically determined by BIOS [Enhanced Mode] Enable both SATA and PATA, max. 6 IDE drives supported [SATA Only] SATA operates in legacy mode SATA Port Speed Settings This setting controls the speed of the SATA port. PATA IDE Mode / SATA Port These settings specify the modes of the PATA & SATA ports. 3-11