MSI B550-A PRO User Manual - Page 61
Creating Arrays, To create an array
View all MSI B550-A PRO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Creating Arrays Arrays can be created after the disks are initialized. ⚠⚠Important ∙∙For redundant arrays, the Create process is not started until after the operating system and AMD-RAID OS drivers have been installed and the system has booted to the operating system. However, the arrays are immediately available to use for either a bootable array or a data array. ∙∙Array numbers are valid only for a given boot and might be different in the RAIDXpert2 Configuration Utility and RAIDXpert2. If a permanent label is required, use the RAIDXpert2 Web GUI Array Naming feature. ∙∙At any point in the procedure, return to a prior window by pressing ESC. ∙∙If the system is booted from an AMD-RAID bootable array, the first array in the Arrays section must be the bootable array. The system boots only from the first array in the Arrays section. To create an array 1. As previously mentioned, enable RAIDXpert2 Configuration Utility. 2. Go to BIOS > SETTINGS > Advanced > RAIDXpert2 Configuration Utility > Array Management > Create Array sub-menu. 3. Select the RAID level from the Select RAID Level drop down menu. 4. Enter Select Physical Disks sub-menu, select member disks by changing the Physical Disk setting to Enabled. 5. Select Apply Changes, then press Enter to apply and go back to previous submenu. 6. Change the Select CacheTagSize, Read Cache Policy and Write Cache Policy settings according to your needs. 7. Select Create Array, then press Enter. AMD RAID Configuration 61