MSI K8N User Guide - Page 31
CD-In Connector: JCD1, Serial ATA/Serial ATA RAID Connectors controlled
View all MSI K8N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
MS-7025 ATX Mainboard Serial ATA/Serial ATA RAID Connectors controlled by nForce3 Ultra: SATA1 / SATA2 / SATA3 / SATA4 The Southbridge of this mainboard is nForce3 Ultra which supports four serial ATA connectors SATA1~SATA4. SATA1~SATA4 are dual high-speed Serial ATA interface ports. Each supports 1st generation serial ATA data rates of 150 MB/s. Both connectors are fully compliant with Serial ATA 1.0 specifications. Each Serial ATA connector can connect to 1 hard disk device. Please refer to the nVidia RAID Introduction for detail software installation procedure. SATA3 SATA4 7 1 SATA2 SATA1 1 7 SATA1~ SATA4 Pin Definition PIN SIGNAL 1 GND 3 TXN 5 RXN 7 GND PIN SIGNAL 2 TXP 4 GND 6 RXP Serial ATA cable Take out the dust cover and connect to the hard disk devices Connect to serial ATA ports MSI Reminds You... Please do not fold the serial ATA cable in a 90-degree angle, which will cause the loss of data during the transmission. CD-In Connector: JCD1 L The connector is for CD-ROM audio connector. JCD1 GND R 2-18