Mackie ART500 Quick Start Guide - Page 2
Rear Panel Features, Installation, Connections - art 500 9 g
View all Mackie ART500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
ART 500 SPEAKER SYSTEM CONCEIVED, DESIGNED, AND MANUFACTURED BY MACKIE INDUSTRIAL • MADE IN ITALY • COPYRIGHT ©1999 THE FOLLOWING ARE TRADEMARKS/REGISTERED TRADEMARKS OF MACKIE DESIGN INC.: "MACKIE", "MACKIE INDUSTRIAL", & THE "RUNNING MAN" FIGURE (SIGNAL)1+ (GROUND)1- 2- (N.C.) ALL CONTACTS PARALLEL WIRED 2+ (N.C.) IMPEDANCE: 8 POWER: 500W SERIAL NUMBER MANUFACTURING DATE Rear Panel Features Connections 1. INPUT is a Neutrik Speakon connector for connecting a speaker-level signal. 2. OUTPUT is a Neutrik Speakon connector that is paralleled with the INPUT jack, for daisy-chaining speakers together. The Speakon connectors use the following wiring standard: Pin 1+ = Signal (+) Pin 1- = Ground (-) 1- 1+ COLD HOT 1- 2+ 1+ 2- Installation A 1-3/8" (35mm) socket is provided in the bottom of the cabinet for mounting the loudspeaker on a speaker stand. The ART500 can be suspended with approved rigging hardware. Always use at least two M10 threaded inserts located on opposite sides of the enclosure. The speaker must be positioned so that the weight of the enclosure is equally distributed over the two inserts. WARNING: Never attempt to suspend the ART Series loudspeakers by their handles. Consult a professional rigger or structural engineer prior to suspending loudspeakers from a structure not intended for that use. Always know the working load limit of the structure supporting the loudspeaker array. Always make sure that the rigging hardware minimum rating is at least five times the actual load.