Mackie CFX20 Spec Sheet - Page 8

CFX SERIES MIXERS CFX Series CFX SERIES 12-, 16-, and 20-Channel Mic/Line Mixers 6. EMAC EFFECTS PROCESSOR. The 32-bit EMAC Digital Stereo Effects Processor shall include 16 preset digital effects algorithms selectable by a detented knob. Effects shall include 9 Reverb types: Spring, Small Room, Medium Plate, Large Plate, Medium Hall, Large Hall, Cathedral, Gated, and Reverse. Effects shall also include 4 Delay Types: Delay 1 providing one repeat, Delay 2 providing two repeats, Delay 3 providing three repeats, and Delay 4 providing four repeats. Effects shall also include 1 Chorus, 1 Flange, and 1 Phaser. Two rotary parameter knobs shall provide control over Time/Rate and Damping/Depth. The EMAC shall include 1 EFX WIDE button providing more width or depth to the effect, and 1 Bypass button that mutes the effect's output signal. The EMAC shall also include 1 EFX 2 Send rotary knob providing up to 15 dB of gain above unity, and control of the dry signal being sent to the input of the EMAC, and 1 To Main Mix rotary knob providing up to 15 dB of gain above unity and control over signals sent from Stereo EFX Return 2. The EMAC shall also include 2 Effects To Monitor rotary knobs labeled Aux 1 & Aux 2 providing up to 15 dB of gain above unity and control over signals sent from Stereo EFX Return 2 and being sent to Aux Sends 1 & 2 and a Clip LED that indicates when the EMAC is 6 dB below clipping. 7. METERING. The mixer shall include 1 stereo 12-segment LED meter with points at -30, -20, -10, -7, -4, -2, 0, +2, +4, +7, +10, and +22 dB. The source signals for the meters shall be the same signals selected in the Left/Right Sub Assign, and a solo condition shall replace the Sub Assign selection with the soloed channel(s). The meters shall be calibrated so that a 0 dBu signal at the Phones output shall be indicated as 0 dB on the meters. 8. PHYSICAL CONFIGURATION. The mixer shall be made of steel and aluminum, painted dark gray and black with light gray graphics. The CFX12 shall weigh 17 lbs, 8 oz. (8.1 kg); the CFX16 shall weigh 21 lbs, 0 oz. (9.5 kg); and the CFX20 shall weigh 24 lbs, 3 oz. (11.0 kg). Optional rackmount brackets shall allow the CFX12 to be mounted in a rack system with the chassis surface flush with the rack rail. The CFX16 and CFX20 are not rackmountable. Dimensions of the CFX12 shall be 17.2" (437 mm) in width, 15.7" (399 mm) in depth, and 5.0" (127 mm) in height. Dimensions of the CFX16 shall be 21.4" (544 mm) in width, 15.7" (399 mm) in depth, and 5.0" (127 mm) in height. Dimensions of the CFX20 shall be 25.6" (650 mm) in width, 15.7" (399 mm) in depth, and 5.0" (127 mm) in height. 9. SPECIFICATIONS. In addition to specifications already cited, the mixers shall meet or exceed the following specifications. Frequency response, microphone input to any output (Trim at 0 dB), 32 Hz to 20 kHz, +0 dB/-1 dB; Total Harmonic Distortion (THD), Mic Input to Main Output: