Mackie MR4T MR4T Quick Start Guide - Page 4

Rear Panel Features and Controls 1. This rotary control selects the power tap for the internal constant voltage transformer. Choices are 1W, 2.5W, 5W, 10W, 20W, and BYPASS (used for 4Ω operation). 2. This rotary control selects the constant voltage distributed system in which the speaker is used. Choices are BYPASS (used for 4Ω operation), 0(Off), 25V, 50V, 70V, and 100V. Connections The spring-loaded speaker terminals are designed to accept bare wire, up to a maximum of 18 gauge. Strip 1/4" of insulation off the end of the speaker wire, press in the tab, and insert the bare wire into the hole. When you release the tab, the wire is locked in place. Make sure there are no stray strands of wire outside the terminal connection. Note: Use a slot-head screwdriver to adjust the rotary controls. + - 3. Use these spring-loaded terminals to connect the speaker wiring. MONITOR 4T 10W 20W 5W 30W 25V 0 1W POWER CAPACITY 60W BYPASS 4 NOMINAL IMPEDANCE 4 50V 70V 100V MADE IN ITALY SERIAL NO. Installation The MONITOR MR4T can be mounted using the optional mounting brackets. These include the following: MA5-6: Plate for suspending 4 clustered speakers, Black MA5-7: Speaker tilt bracket for MA5-6, Black MA5-9 (MA5-9W): U-bracket, Black (White) MA-7B (MA-7W): Wall-mount support bracket, Black (White) WARNING: Consult a professional rigger or structural engineer prior to suspending loudspeakers from a structure not intended for that use. Always know the working load limit of the structure supporting the loudspeaker array. Always make sure that the rigging hardware minimum rating is at least five times the actual load. 4