Mackie SR1530 Owner's Manual - Page 8
Care and Maintenance, SR1530 Specifications, Transducer Specifications, Power Amplifiers
View all Mackie SR1530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
CARE AND MAINTENANCE Your Mackie loudspeakers will provide many years of reliable service if you follow these guidelines: Avoid exposing the loudspeakers to moisture. If they are set up outdoors, be sure they are under cover if you expect rain. • Avoid exposure to extreme cold (below freezing temperatures). If you must operate the loudspeakers in a cold environment, warm up the voice coils slowly by sending a low-level signal through them for about 15 minutes prior to high-power operation. • Use a slighty damp cloth with a mild soap solution to clean the cabinets. Only do this when the power is turned off. Avoid getting moisture into any of the openings of the cabinet, particularly where the drivers are located. SR1530 SPECIFICATIONS System Specifications Frequency Range (-10 dB) 40Hz-20kHz Frequency Response (-3 dB) 45Hz-18kHz Horizonal Coverage Angle (-6 dB) 90º averaged 2kHz to 10kHz Vertical Coverage Angle (-6 dB) 40º averaged 2kHz to 10kHz Directivity Factor; DI (Q) 10.77 (11.95) averaged 2kHz to 10kHz Maximum SPL @ 1m 123 dB Peak Output @ 1m 126 dB Crossover Points 700Hz, 3000Hz Dynamic Range > 100 dB Phase Response ± 40º from 500Hz to 10kHz Input Type Balanced differential Input Impedance 50K ohms Input Protection Monitoring and limiting of continuous rms output of amplifiers Thermal Protection Input stage muting, auto-reset Transducer Specifications Low-Frequency Transducer Diameter Voice Coil Diameter Power Handling 15˝ (381mm) 2.5˝ (63mm) 250W rms (long term)1 8 Mid-Frequency Transducer Diameter Voice Coil Diameter Power Handling 6˝ (152mm) 2˝ (50mm) 60W rms (long term)1 High-Frequency Transducer Diaphragm Diameter Voice Coil Diameter Power Handling Diaphragm Material 1˝ (25mm) 1˝ (25mm) 25W rms (long term)1 Mylar Power Amplifiers Low-Frequency Power Amplifier Rated Power Rated THD Design 300 watts RMS < 0.05% Class G, High Efficiency/High Current Mid and High-Frequency Power Amplifiers Rated Power Rated THD Design 100 watts RMS < 0.1% Integrated Module Line Input Power US 120V, 60Hz Recommended Amperage Service: Europe 230V, 50Hz Recommended Amperage Service: 8 amps 5 amps Physical Properties Height Front Width Rear Width Depth Weight Enclosure Mounting Methods 43.9˝ (1116mm) 19.1˝ (484mm) 13.9˝ (352mm) 18.1˝ (460mm) 111.25 lbs. (50.57 kg) Trapezoidal, 10º sides, 18mm multi-layered plywood, top and bottom high pressure resin injected "caps" Floor mount only. The SR1530 should never be pole-mounted. The cabinet has no rigging points and is not suitable for flying. Never attempt to suspend the cabinet by its handles. 1 Power handling for transducers is based on an AES long term power testing standard conducted for 100 hours full power, free air. Disclaimer Since we are always striving to make our products better by incorporating new and improved materials, components, and manufacturing methods, we reserve the right to change these specifications at any time without notice. "Mackie" and the "Running Man" figure are trademarks or registered trademarks of Mackie Designs Inc. All other brand names mentioned are trademarks or registered trademarks of their respective holders, and are hereby acknowledged. ©2002 Mackie Designs Inc. All Rights Reserved. Rev. D 03/02