Macrom M-DVD5561R User Manual (English) - Page 34
Device connections
View all Macrom M-DVD5561R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Device connections Notes of connection This unit is designed to be used in a vehicle with a 12-volt battery and negative grounding. Before installing this unit to a recreational vehicle, a bus, or a truck, make sure the battery voltage is appropriate for this unit to be used, otherwise, install a transformer by professional to convert the output voltage to 12V. To avoid short circuit in the electrical system, ensure that the negative battery cable is disconnected before installation. To prevent short circuit in the wiring and damaging to this unit, secure all wirings with cable clamp or adhesive tape. Route the wirings in a secured, out of heating place without touching any moving parts such as gear shift, handbrake, and seat rails to prevent the wiring insulation being melted / wore off. Never pass the yellow power cord through the installation hole into the engine compartment and connect to the car battery. Otherwise, a high possibility of serious short circuit to the electrical system may be occurred. Replacing a new fuse with 10A rating when the old one is broken, using no fuse or fuse with improper rating may cause damage to this unit or even fires. If a proper fuse is installed and electrical problems still occur, please contact with any professional car shops for inquiry. DO NOT connect other equipments with the car battery to avoid battery overheating. Please make sure all the wiring connections & the cables of the speakers are well-insulated. Otherwise, this unit may be damaged by short circuit. If there is no ACC available,Please connect ACC lead to the power supply with a switch. If an external power amplifier is connected, please don't connect P.CONT lead to the power lead of the external power amplifier, otherwise, electric spark or other damage may be resulted. Never ground the speaker output to prevent the damage to the built-in power amplifier. The minimum rating of the speakers connected to this unit is 50W with 4 to 8Ω impedance. 29