Macrom M-HPB20 User manual (Italian-English) - Page 6

EN Pairing and connecting with a Bluetooth device To enter pairing mode, make sure the headphone is powered off then press and hold the MFB key about 6 seconds until the headphone prompts the "Power ON" and "Pairing" voice messages and the indicator LED blinks red and blue alternately. From the Bluetooth function of the device to be paired search for new device named "M-HPB20". Select it and if requested enter "0000" passcode. When pairing is completed successfully the indicator LED blinks blue and the headphone prompts the "Pairing Completed" voice message. If the pairing procedure is not successful, please switch off the headphone and repeat the above steps. The specific pairing procedure may vary, so please refer to your device user manual for further information. Multilink technology allows simultaneous connection of two different devices. To connect the second device simply repeat the above procedure. Re-connecting with a Bluetooth device Every time the headphone is switched on, it will connect to the last connected device automatically. When the headphone is in standby mode and doesn't connect to any HFP devices, short press MFB button once, it will connect to last connected source device automatically. Adjust the Volume To adjust the headphone volume during a call or while listening to music press the volume up or down keys. When the volume is turned to maximum or minimal levels, a "BIP" tone is prompted. Please remember that excessive sound pressure from headphones can damage your hearing. -6- Manuale di istruzioni M-HPB20 red_ ENG-IT.indd 6 04/04/2013 10:39:57