Magic Chef HMM1611ST User Manual - Page 7

,167$//$7,21 1. ([DPLQH WKH RYHQ DIWHU XQSDFNLQJ Check for damage such as a misaligned door, broken door or dent in the cavity. If any damage is visible, DO NOT INSTALL, and notify your dealer immediately. 2. /HYHO IODW ORFDWLRQ Install the microwave oven on a level, flat surface. 3. 9HQWLODWLRQ Do not block air vents. If they are blocked during operation, the oven may overheat and eventually cause a failure. For proper ventilation, allow 4 inches (10.16 cm) of space between oven top, sides, rear and adjacent surfaces. 4. $ZD\ IURP UDGLR DQG 79 VHWV Poor television reception and radio interference may result if the oven is located close to a TV, radio, antenna, feeder, etc. Place the oven as far from them as possible. 5. $ZD\ IURP KHDWLQJ DSSOLDQFHV DQG ZDWHU WDSV Keep the oven away from heat, steam or splashing liquids. These things can adversely affect oven wiring and contacts. 6. 3RZHU VXSSO\ • Check your local power source. This microwave oven requires a current of approximately 12 amperes, AC 120Volts, 60Hz grounded outlet. 1. A short power-supply cord is provided to reduce the risks resulting from becoming entangled in or tripping over a longer cord. 2. Longer cord sets or extension cords are available and may be used if care is exercised in their use. 3. If a long cord or extension cord is used: • The marked electrical rating of the cord set or extension cord should be at least as great as the electrical rating of the appliance. • The extension cord must be a grounding type 3-wire cord. • The longer cord should be arranged so that it will not drape over the counter top or tabletop where it can be pulled on by children or tripped over unintentionally. 7. 7KH PLQLPXP KHLJKW RI IUHH VSDFH QHFHVVDU\ DERYH WKH WRS VXUIDFH RI WKH RYHQ LV DERXW  LQFKHV  FP  :KHQ XVH SURQJHG SOXJ :KHQ XVH JURXQGLQJ DGDSWRU PDNH VXUH WKH UHFHSWDFOH ER[ LV IXOO\ JURXQGHG 3-prong Receptacle Receptacle Box cover Grounding Lead Receptacle Box Cover 3-prong plug Grounding Receptacle Adaptor "THE CANADIAN ELECTRICAL CODE DOES NOT ALLOW THE USE OF THE GROUNDING ADAPTOR" (1