Magnavox 32MV322R/F7 _QSG_EN - Page 7

Notice MAGNAVOX and SMART. VERY SMART. are registered trademarks of Koninklijke Philips N.V. and are used under license from Koninklijke Philips N.V. Funai reserves the right to change products at any time without being obliged to adjust earlier supplies accordingly. The material in document is believed adequate for the intended use of the system. If the product or its individual modules or procedures are used for purposes other than those specified herein, confirmation of their validity and suitability must be obtained. Funai warrants that the material itself does not infringe any United States patents. No further warranty is expressed or implied. Funai cannot be held responsible neither for any errors in the content of document nor for any problems as a result of the content in document. Errors reported to Funai will be adapted and published on the Funai support website as soon as possible. Pixel characteristics This LCD product has a high number of color pixels. Although it has effective pixels of 99.999 % or more, black dots or bright points of light (red, green or blue) may appear constantly on the screen. This is a structural property of the display (within common industry standards) and is not a malfunction. Warranty No components are user serviceable. Do not open or remove covers to the inside of the product. Repairs may only be done by service centers and official repair shops. Failure to do so shall void any warranty, stated or implied. Any operation expressly prohibited in document, any adjustments or assembly procedures not recommended or authorized in document shall void the warranty. Federal communications commission notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and the receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio or television technician for help. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2)This device must accept interference received, including interference that may cause undesired operation. Declaration of conformity Trade name: MAGNAVOX Responsible party: Funai Corporation, Inc. Model: 32MV322R/F7 Address: 12489 Lakeland Road, Santa Fe Springs, CA 90670, USA Telephone number: 1 866 341 3738 Modifications This apparatus may generate or use radio frequency energy. Changes or modifications to this apparatus may cause harmful interference. Any modifications to the apparatus must be approved by Funai Corporation. The user could lose the authority to operate this apparatus if an unauthorized change or modification is made. Cables Connections to this device must be made with shielded cables with metallic RFI / EMI connector hoods to maintain compliance with FCC rules and regulations. Canadian notice CAN ICES-3(B) / NMB-3(B) Analog and digital television receiving apparatus, Canada BETS-7/NTMR-7. The following FCC/IC RSS applies to the wireless LAN adapter included in this product. FCC caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. FCC/IC RF Exposure Compliance This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment should be installed and operated keeping the radiator at least 20 cm or more away from your body. This device complies with Part 15 of FCC Rules and Industry Canada licenceexempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of this device. 5150-5250 MHz band is restricted to indoor operations only. High-power radars are allocated as primary users (i.e.priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices. Compliance with FCC requirement 15.407(c) and IC requirement RSS-210 A9.4.4 Data transmission is always initiated by software, which is the passed down through the MAC, through the digital and analog baseband, and finally to the RF chip. Several special packets are initiated by the MAC. These are the only ways the digital baseband portion will turn on the RF transmitter, which it then turns off at the end of the packet. Therefore, the transmitter will be on only while one of the aforementioned packets is being transmitted. In other words, this device automatically discontinue transmission in case of either absence of information to transmit or operational failure. Positioning the TV • Large screen TVs are heavy. 2 people are required to carry and handle a large screen TV. • Make sure to hold the upper and bottom frames of the unit firmly as illustrated. • Install the unit in a horizontal and stable position. • Do not install the unit in direct sunlight or in a place subject to dust or strong vibration. • Depending on the environment, the temperature of this unit may increase slightly. This is not a malfunction. • When installing this unit in a temperate environment, avoid a place with rapid temperature changes. - Operating temperature: 41°F (5°C) to 104°F (40°C) • This unit should not be used in a tropical environment as it has not been evaluated under such conditions. • No objects should be placed directly on or under this unit, especially lighted candles or other flaming objects. • Depending on your external devices, noise or disturbance of the picture and / or sound may be generated if the unit is placed too close to them. In this case, please ensure enough space between the external devices and the unit. • Do not insert the AC power cord into the power socket outlet before all the connections are made. • Ensure that you always have easy access to the AC power cord and outlet to disconnect the TV from the AC outlet. • Before you move the TV, disconnect attached cables to prevent damage to connectors, especially the TV tuner. • Be sure to unplug the AC power plug from the AC outlet before moving or carrying the unit. • When moving the TV and then setting it down, please be careful not to pinch the AC power cord under the unit. Regulatory notices WARNING: To prevent injury, this apparatus must be securely attached to the furniture / wall in accordance with the instructions. Tipping, shaking or rocking the unit may cause injury / death. Stability Hazard A television set may fall, causing serious personal injury or death. Never place a television set in an unstable location. Many injuries, particularly to children, can be avoided by taking simple precautions such as: - Always use cabinets, stands or mounting instruction recommended by the manufacturer of the television set. - Always use only furniture that can safety support the television set. - Always ensure the television set is not overhanging the edge of the supporting furniture. - Always educate children about the dangers of climbing on furniture to reach the television set or its controls. - Certainly wire the cords and cables connected to television set that cannot be routed, pulled and pinched. - Not placing the television set on unstable place. - Not placing the television set on tall furniture (for example, cupboards or bookcases) without anchoring both the furniture and the television set to a suitable support. - Not placing the television set on cloth or other materials that may be located between the television set and supporting furniture. - Not placing anything such as toys or controls that tempts children on a TV or furniture which a TV is placed. If the existing television set is going to be retained and relocated, the same considerations as above should be applied. Do not place the unit on the furniture that is capable of being tilted by a child and an adult leaning, pulling, standing or climbing on it. A falling unit can cause serious injury or even death. In order to avoid interruption of ventilation, this unit should not be placed in built-in equipment such as a book cabinet, rack, etc., and the vents of this unit should not be covered with anything such as a tablecloth, curtain, newspaper, etc. Make sure that there is enough ventilation space (4 inches / 10 cm or more) around this unit. Press B to turn the unit on and go into standby mode. To completely turn off the unit, you must unplug the AC power plug from the AC power outlet. Disconnect the AC power plug to shut the unit off when trouble is found or not Einnuse. The AC plug shall remain readily available. AC power plug Never use a gas duster on this TV. The gas trapped inside of this unit may cause ignition and explosion.