Magnavox MT1905B User manual, English (US) - Page 3

HOOKING UP YOUR TV (ANTENNA/CABLE CONNECTIONS) (CONT'D) VCR TO TV BASIC CONNECTION T he basic Antenna/Cable to VCR to TV connection is shown here. If you have a Cable Box, refer to the VCR owner's manual for details. Connect your Antenna or Cable signal to the IN FROM ANT(enna) jack on the VCR. Connect a coaxial cable (not supplied) to the OUT TO TV jack on the VCR and to the ANT(enna) IN jack on the TV. Refer to the VCR owner's manual for other possible connections and for operating details. Outdoor VHF/UHF Antenna 300 to 75Ω Adapter OR Cable TV signal Back of VCR IN FROM ANT. OUT TO TV Coaxial cable VCR ANT.IN Back of TV CABLE TV CABLE/CABLE BOX Your Cable TV signal may be a single (75Ω) cable or a Cable Box installation. In either case, the connection to the TV is very easy. If you do not have a Cable Box, then you're ready to connect your Cable TV signal to the TV. Go to step 2. If you have a Cable Box: Connect the Cable TV signal to the IN jack on the Cable Box. If you do not have a Cable Box, connect the Cable TV signal directly to the ANT(enna) IN jack on the TV. If you have a Cable Box: Use a coaxial cable (not supplied) to connect the OUT jack of the Cable Box to the ANT(enna) IN jack on the TV. Note to the Cable TV System Installer: This reminder is provided to call the Cable TV system installer's attention to Article 820-40 of the National Electrical Code, which provides guidelines for proper grounding - in particular, specifying that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as possible. Cable TV Signal (75Ω) Cable TV Company IN OUT Cable Box OR Coaxial cable - 3 - ANT.IN Back of TV SMART HELP To select only the channels on your Cable system, see Auto Install (page 4). If you use a Cable Box, set the TV to the same channel as the CH 3/4 switch on the back of the Cable Box. Select channels at the Cable Box.