Magnavox P-09NPE Portable AC remote manual - Page 3

Function Buttons Before you begin using your new air conditioner, make sure to familiarize yourself with its remote control. The following is a brief introduction to the remote control itself. For instructions on how to operate your air conditioner, refer to the How to Use Basic Functions section of this manual. ON/OFF Turns the unit on or off. MODE Scrolls through operation modes as follows: AUTO COOL DRY HEAT FAN NOTE Please do not select HEAT mode if the machine you purchased is cooling only type. Heat mode is not supported by the cooling only appliance. FAN SPEED Selects fan speeds in the following order: AUTO LOW MED HIGH ON/OFF MODE FAN TEMP SHORT CUT TIMER ON TIMER OFF SLEEP SWING LED SLEEP Saves energy during sleeping hours. SWING Starts and stops louver movement. SHORT CUT Sets and activates your favorite pre-settings. TEMP Increases temperature in 1°F increments. Max. temperature is 86°F. TEMP Decreases temperature in 1°F increments. Min. temperature is 62°F. TIMER ON Sets timer to turn unit on (see How to Use Basic Functions for instructions) TIMER OFF Sets timer to turn unit off (see How to Use Basic Functions for instructions) LED Turns indoor unit,s LED display on and off. If you are sensitive to light when you go to sleep, you can press the LED button to turn off the LED display on the unit. Press the button again to turn it back on. 3 Handling The Remote Control NOT SURE WHAT A FUNCTION DOES? Refer to the How to Use Basic Functions and How to Use Advanced Functions sections of this manual for a detailed description of how to use your air conditioner. SPECIAL NOTE Button designs on your unit may differ slightly from the example shown. If the indoor unit does function, pressing that nfuont chtaiovne, a particular s button on the remote control will have no effect. When there are wide differences between ,, Remote Control Illustration and ,, USER'S MANUAL on function description, ,, the description of USER'S MANUAL ,, shall prevail. ,,,, TIPS FOR USING REMOTE CONTROL The remote control must be used within 26FT of the unit. The unit will beep when remote signal is received. Curtains, other materials and direct sunlight can interfere with the infrared signal receiver. Remove batteries if the remote will not be used more than 2 months. Inserting and Replacing Batteries Your air conditioning unit comes with two AAA batteries. Put the batteries in the remote control before use. 1. Slide the back cover from the remote Control downward, exposing the battery compartment. 2. Insert the batteries, paying attention to match up the (+) and (-) ends of the batteries with the symbols inside the battery compartment. 3. Slide the battery cover back into place. BATTERY NOTES For optimum product performance: Do not mix old and new batteries, or batteries of different types. Dif oyonuotdloena,vt eplbaanttoenrieussiinngththeeredmevoictee control for more than 2 months. BATTERY DISPOSAL Do not dispose of batteries as unsorted municipal waste. Refer to local laws for proper disposal of batteries. 4