Magnavox ZV457MG9 User manual, English (US) - Page 43

Introduction Connections Basic Setup TIMER RECORDING You can program the unit to record up to 12 programs within a month in advance. Daily or weekly program recordings are also available. Before recording, make sure to • Set the clock before setting a timer programming. • Insert a recordable disc with enough recordable space. Guide to Timer Programming Display 3 1 2 Timer Programming JAN/ 2/09 12:00 AM 69.1 SP SP (1:00) THU JAN/01 11:00AM Date Start End CH JAN/02 12:00AM 1:00AM DTV69. 1 6 New Program Recording Playback Editing 1/1 4 5 1 Title of a timer program (Contains date, time, channel, recording mode of the program) 2 Current date and time 3 Recording mode, and length of the recording 4 Timer program list 5 Total number of pages and current page (2 pages maximum) 6 Recording media (" " (DVD) or " " (VCR)) 1 Press [TIMER]. 2 Use [K / L] to select "New Program", then press [OK]. Timer Programming Date THU JAN/01 11:00AM Start End CH New Program Note • If you have not set the clock yet: Entry screen for the clock setting will appear instead of the timer programming list at step 1. Continue with the step 5 in "Manual Clock Setting" on page 32 before setting a timer programming. • Use [s / B] to move the cursor to the left and the right in the entry screen for the timer programming. • If a basic recording or one-touch timer recording is in progress on one component (e.g., VCR) and the timer recording set for the other component (e.g., DVD) is about to begin, the unit automatically switches to the programmed channel for timer recording 2 minutes before the programmed starting time, and the recording in progress (for VCR) will be cancelled UNLESS their recording channels are the same. If their recording channels are the same, the timer recording will start without canceling the recording currently in progress. In this case, the recording of the same channel will be made on both DVD and VCR. • You cannot make a program whose recording time exceeds 12 hours. • Cancel the timer-standby mode by pressing [TIMER SET] before operation for either DVD or VCR. When finished operating, press [TIMER SET] to resume the timer-standby mode. • In the timer-standby mode, you can turn on the power and use the component (VCR or DVD) which is not currently timer-programmed. • If there are 6 or more programs, use [H / G] to change pages. 3 Use [K / L] to enter the date, then press [B]. Date JAN/02 CH DTV69. 1 Start - - : - REC To DVD End - - : - Mode SP SP 2h00m JAN/01 Daily MON-SAT MON-FRI SAT FRI When pressing [L] at the current date, the date will change as follows. e.g.) January 1st SUN JAN/31 EN 43 Function Setup VCR Functions Others Español