Makita 1902 Owners Manual - Page 11

Maintenance

Get Makita 1902 PDF manuals and user guides View all Makita 1902 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

003634 Chamfering To make a chamfering cut as shown in the figure, align the "V" groove in the front base with the edge of the workpiece and plane it. 002587 1 1. "V"groove MAINTENANCE CAUTION: • Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. 1. Limit mark 001145 Replacing carbon brushes Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use only identical carbon brushes. 1 002597 Use a screwdriver to remove the chip cover. 1 2 1. Chip cover 2. Screwdriver 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
11
Chamfering
To make a chamfering cut as shown in the figure, align the
“
V
”
groove in the front base with the edge of the workpiece
and plane it.
MAINTENANCE
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.
Replacing carbon brushes
Remove and check the carbon brushes regularly. Replace
when they wear down to the limit mark. Keep the carbon
brushes clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only iden-
tical carbon brushes.
Use a screwdriver to remove the chip cover.
1.
“
V
”
groove
003634
1
002587
1. Limit mark
1
001145
1. Chip cover
2. Screwdriver
1
2
002597