Makita 2705 Owners Manual - Page 7
Assembly - table saws
View all Makita 2705 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
To use the sub table (back), loosen the screws on the left and right hand sides under the table and pull it out backwards to the desired length. At the desired length, tighten the screw securely. 1. Wrench 2. Hex nut 1 3. Offset wrench NOTE: • When using the sub table (back ) during use of the rip fence, pull out the sub table (back) more than 50 mm so that it does not hit against the top end of the rip fence. 1 2 1. Screw 2. Sub table (L) 1 006151 Sub table (back) can be installed at the back of the table to assure wider space. Sub table (L) can be installed on the left side of the table. ASSEMBLY Overview of Table Saw Blade Guarding System 1 2 4 008941 5 3 1. Table saw blade guard assembly 2. Antikickback pawls 3. Riving knife/spreader 4. Riving knife/ spreader release lever location 5. Table saw blade side guards WARNING: • Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. The saw blade and blade guard are not installed on the tool when it is shipped from the factory. Installing or removing saw blade WARNING: • Always be sure that the tool is switched off and unplugged before installing or removing the blade. • Use only the Makita socket wrench provided to install or remove the blade. Failure to do so may result in overtightening or insufficient tightening of the hex bolt. This could cause an injury. 3 2 008730 Remove the table insert on the table. Hold the outer flange with the offset wrench and loosen the hex nut counterclockwise with the wrench. Then remove the outer flange. Assemble the inner flange, blade, outer flange and hex nut onto the arbor, making sure that the teeth of the blade are pointing down at the front of the table. Always install the hex nut with its recessed side facing the outer flange. 1. Inner flange 1 24 2. Outer flange 3. Saw blade 4. Hex nut 3 006136 CAUTION: • Keep the flange surface clean of dirt or other adhering matter; it could cause blade slippage. Be sure that the blade is installed so that the teeth are aligned in the cutting (turning) direction. To secure the blade in place, hold the outer flange with the offset wrench, then tighten the hex nut clockwise with the wrench. BE SURE TO TIGHTEN THE HEX NUT SECURELY. 1. Wrench 1 2. Offset wrench 2 008731 CAUTION: • Be sure to hold the hex nut carefully with the wrench. If your grip should slip, the wrench may come off the hex nut, and your hand could strike 7