Makita 2705X1 Owners Manual - Page 5
Functional Description - 10
View all Makita 2705X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
1 25 mm (1") 2 006146 1 1. 6 mm (1/4") Std. washer 2. No.10 wood screw 40 mm (1-1/2") min. length 1. 6 mm (1/4") Std. washer 2. 6 mm (1/4") Mounting bolt & Nut tighten 2 securely The depth of cut may be adjusted by turning the handle. Turn the handle clockwise to raise the blade or counterclockwise to lower it. NOTE: • Use a shallow depth setting when cutting thin materials in order to obtain a cleaner cut. Adjusting the bevel angle 1 1. Lock lever 2 2. Arrow pointer 3. Handwheel 3 006155 006148 Locate the table saw in a well lit and level area where you can maintain good footing and balance. It should be installed in an area that leaves enough room to easily handle the size of your workpieces. The table saw should be secured with four screws or bolts to the work bench or table saw stand using the holes provided in the bottom of the table saw. When securing the table saw on the work bench, make sure that there is an opening in the top of the work bench the same size as the opening in the bottom of the table saw so the sawdust can drop through. If during operation there is any tendency for the table saw to tip over, slide or move, the work bench or table saw stand should be secured to the floor. FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Adjusting the depth of cut 1. Handle Loosen the lock lever counterclockwise and turn the handwheel until the desired angle (0° - 45°) is obtained. The bevel angle is indicated by the arrow pointer. After obtaining the desired angle, tighten the lock lever clockwise to secure the adjustment. CAUTION: • After adjusting the bevel angle, be sure to tighten the lock lever securely. Adjusting positive stops 1. 90 ゚ Adjusting screw 2. 45 ゚ Adjusting screw 1 006156 (A) 90 90 2 45 45 (B) 1 006157 006154 The tool is equipped with positive stops at 90° and 45° to the table surface. To check and adjust the positive stops, proceed as follows: 5