Makita 4100KB 4100KB Instruction Manual - Page 6
Assembly
View all Makita 4100KB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Switch action CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. 1 2 ASSEMBLY CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Hex wrench storage When not in use, store the hex wrench as shown in the figure to keep it from being lost. ► 1 . Switch trigger 2. Lock button / Lock-off button For tool with lock button CAUTION: Switch can be locked in "ON" position for ease of operator comfort during extended use. Apply caution when locking tool in "ON" position and maintain firm grasp on tool. To start the tool, simply pull the switch trigger. Release the switch trigger to stop. For continuous operation, pull the switch trigger, push in the lock button and then release the switch trigger. To stop the tool from the locked position, pull the trigger fully, then release it. For tool with lock-off button To prevent the switch trigger from being accidentally pulled, a lock-off button is provided. To start the tool, press the lock-off button and pull the switch trigger. Release the switch trigger to stop. WARNING: NEVER use the tool if it runs when you simply pull the switch trigger without pressing the lock-off button. A switch in need of repair may result in unintentional operation and serious personal injury. Return tool to a Makita service center for proper repairs BEFORE further usage. WARNING: NEVER defeat the lock-off button by taping down or some other means. A switch with a negated lock-off button may result in unintentional operation and serious personal injury. CAUTION: Do not pull the switch trigger hard without pressing in the lock-off button. This can cause switch breakage. 1 ► 1 . Hex wrench Removing or installing diamond wheel CAUTION: BE SURE TO TIGHTEN THE HEX BOLT SECURELY. Also be careful not to tighten the bolt forcibly. Slipping your hand from the hex wrench can cause a personal injury. CAUTION: Use only the Makita wrench and hex wrench to install or remove the wheel. Hold the outer flange with the wrench and loosen the hex bolt with the hex wrench. Then remove the hex bolt, outer flange and diamond wheel. 1 5 4 2 3 ► 1 . Hex wrench 2. Hex bolt 3. Wrench 22 4. Loosen 5. Tighten To install the diamond wheel, follow the removal procedure in reverse. Always install the wheel so that the arrow on the diamond wheel points in the same direction as the arrow on the gear housing. 6 ENGLISH