Makita 4100NHX1 Instruction Manual - Page 5

19. Do not stop the wheel by lateral pressure on the disc. 20. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. Follow material supplier safety data. 21. The tool must be used only for dry cutting. DO NOT use water. SAVE THESE INSTRUCTIONS. base by tightening the wing bolt. CAUTION: • After adjusting the depth of cut, always tighten the wing bolt securely. Sighting WARNING: MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. USD201-2 Symbols The followings show the symbols used for tool. ･ volts ･ amperes ･ hertz ･ alternating current ･ no load speed ･ Class II Construction ･ revolutions or reciprocation per minute 007693 Align the edge of the front of the base with your cutting line on the workpiece. Switch action CAUTION: • Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. 1. Switch trigger 1 2 2. Lock-off button FUNCTIONAL DESCRIPTION 007692 CAUTION: • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Adjusting the depth of cut 1. Wing bolt 2. Base 1 To prevent the switch trigger from being accidentally pulled, a lock-off button is provided. To start the tool, push in the lock-off button and pull the switch trigger. Release the switch trigger to stop. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. 2 007691 Loosen the wing bolt on the depth guide and move the base up or down. At the desired depth of cut, secure the 5