Makita 5377MG Owners Manual - Page 6
Save These Instructions., Symbols, Functional Description - circular saw
View all Makita 5377MG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
support of the saw. Fig. 4 Fig. 7 A typical illustration of proper hand support, workpiece support, and supply cord routing. 000161 16. Place the wider portion of the saw base on that part of the workpiece which is solidly supported, not on the section that will fall off when the cut is made. As examples, Fig. 5 illustrates the RIGHT way to cut off the end of a board, and Fig. 6 the WRONG way. If the workpiece is short or small, clamp it down. DO NOT TRY TO HOLD SHORT PIECES BY HAND! Fig. 5 000152 18. WARNING: Blade coasts to stop after switch is released. Contact with coasting blade can cause serious injury. Before setting the tool down after completing a cut, be sure that the lower (telescoping) guard has closed and the blade has come to a complete stop. 19. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. Follow material supplier safety data. SAVE THESE INSTRUCTIONS. 000163 Fig. 6 WARNING: MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. USD101-2 Symbols The followings show the symbols used for tool. ・ volts ・ amperes ・ hertz ・ alternating current ・ no load speed ・ revolutions or reciprocation per minute 000165 17. Never attempt to saw with the circular saw held upside down in a vise. This is extremely dangerous and can lead to serious accidents. FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. 6