Makita 6952 Owners Manual - Page 7
Assembly
View all Makita 6952 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ASSEMBLY CAUTION: • Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. 12 mm (15/32") 001266 9 mm (3/8") Installing or removing driver bit or socket bit Use only the driver bit or socket bit shown in the figure. Do not use any other driver bit or socket bit. 1 1. Bit 2. Sleeve 1. Hook 001267 To install the bit, pull the sleeve in the direction of the arrow and insert the bit into the sleeve as far as it will go. Then release the sleeve to secure the bit. To remove the bit, pull the sleeve in the direction of the arrow and pull the bit out firmly. 2 NOTE: • If the bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the bit will not be secured. In this case, try re-inserting the bit according to the instructions above. Hook The hook is convenient for temporarily hanging the tool. This can be removed without using a tool.This can be installed on either side of the tool. 004355 Installing and removing hook Expand the upper part of the hook in both directions and remove it. To install the hook, follow the removal procedure in reverse. 1 7