Makita BJS130 Owners Manual - Page 6
Operation - parts
View all Makita BJS130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Replacing cutting head for capacity of gauge 16 (Optional Accessory) 1. Remove the cutting head. (Refer to the section titled " Removing cutting head ".) Hex wrench storage 1. Hex wrench 1 009021 009050 2. Loosen the bearing assembly with provided wrench while keeping the spindle still by grabbing the two flat parts on the spindle still with another wrench. When not in use, store the hex wrench as shown in the figure to keep it from being lost. Carry hook The carry hook is convenient for temporarily hooking the tool. It can be installed on either side of the tool. When removing the carry hook, widen it by pressing its right ends ON BOTH SIDES in the directions of arrow (1) and raise it in the direction of the arrow (2). 1. Hook 1 009051 3. Remove the bearing assmbly (thin one) and screw the bearing assembly for gauge 16 onto the spindle and firmly tighten it with the provided wrench while keeping the spindle still by placing another wrench on the two flat surface on the spindle. 4. Install the optional cutting head by referring to the section titled " Installing cutting head ". CAUTION: • Do not confound the bearing assembly provided on the tool (thin one) with that for cutting head for capacity of gauge 16 (Optional Accessory). The bearing assembly provided on the tool is thin while that for cutting head for capacity of gauge 16 (Optional Accessory) is thick. 2 1 1 009015 OPERATION 009020 1 2 1. Side blade 2. Side blade surface 3. Center blade 4. Workpiece 3 4 009018 6