Makita BSS610Z Owners Manual - Page 8
Assembly - accessories
View all Makita BSS610Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Lighting the lamp CAUTION: • Do not look in the light or see the source of light directly. Only to turn on the light, pull the switch trigger without pressing the lock-off lever.To turn on the light and run the tool, press the lock-off lever and pull the switch trigger with the lock-off lever being pressed. NOTE: • Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. • Do not use gasoline, thinner or the like to clean the lens of lamp. Using such substances will damage the lens. ASSEMBLY 006707 1. Inner flange 2 4 2. Saw blade 3. Outer flange 3 4. Hex. bolt 1 When changing blade, make sure to also clean upper and lower blade guards of accumulated sawdust. Such efforts do not, however, replace the need to check lower guard operation before each use. Hex wrench storage 1 006708 1. Hex wrench CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Removing or installing saw blade 006706 1. Shaft lock 2. Hex wrench 1 2 When not in use, store the hex wrench as shown in the figure to keep it from being lost. Connecting a vacuum cleaner 006711 1. Dust nozzle (accessory) 2. Screw CAUTION: • Be sure the blade is installed with teeth pointing up at the front of the tool. • Use only the Makita wrench to install or remove the blade. To remove the blade, press the shaft lock so that the blade cannot revolve and use the wrench to loosen the hex bolt clockwise. Then remove the hex bolt, outer flange and blade. To install the blade, follow the removal procedure in reverse. BE SURE TO TIGHTEN THE HEX BOLT COUNTERCLOCKWISE SECURELY. 1 2 1 2 006712 1. Hose 2. Vacuum cleaner When you wish to perform clean cutting operation, connect a Makita vacuum cleaner to your tool. Install the dust nozzle on the tool using the screw. Then connect a hose of the vacuum cleaner to the dust nozzle as shown in the figure. 8