Makita CJ102DZL CJ102DZ Instruction Manual - Page 4
Save These Instructions.
View all Makita CJ102DZL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
• Be careful not to drop or strike battery. • Do not use a damaged battery. • Follow your local regulations relating to disposal of battery. Tips for maintaining maximum battery life • Never recharge a fully charged battery cartridge. Overcharging shortens the battery service life. • Charge the battery cartridge with room temperature at 10°C - 40°C (50°F - 104°F). • Let a hot battery cartridge cool down before charging it. • Charge the battery cartridge once in every six months if you do not use it for a long period of time. • For an optimum life-time, the battery cartridge have to be fully charged, after use. SAVE THESE INSTRUCTIONS. DESIGNATION OF PARTS (Fig. 1) 1. Power button 2. Battery holder pocket (Backside) 3. Power cable (Inside the battery holder pocket) 4. Hole for strap 5. Battery holder (See the last part of this instruction manual for all the illustrations.) SPECIFICATIONS Model CJ102D/CJ103D Temperature adjustment steps 3 Material Outer shell: - Polyester (94%) - Spandex (6%) Inner shell: - Polyester (100%) USB power supply port DC 5V, 2.1A Operating time (h) (With battery BL1041B) Low Medium High APPROX. 14 APPROX. 7.5 APPROX. 4.0 Rated voltage (V) DC 10.8 V - 12 V max Battery cartridge BL1016, BL1021B, BL1041B • Due to our continuing program of research and development, the specifications herein are subject to change without notice. • Specifications and battery cartridge may differ from country to country. • Operating time may differ depending on battery type and usage condition. FUNCTIONAL DESCRIPTION Switch action To turn on the jacket, push and hold the power button (about 1.5 seconds). To turn off, push and hold the power button again. Temperature adjustment There are three temperature settings (high, medium, low). Three LED lights means that the temperature is set to "high", two LED lights "medium", and one LED light "low". When you switch on the jacket, the temperature is set to "high". Each press of the power button cycles through the jacket's temperature setting. Indicating the remaining battery capacity (Fig. 2) (Only for battery cartridges with "B" at the end of the model number.) Press the check button (7) on the battery cartridge to indicate the remaining battery capacity. The indicator lamps (6) light up for few seconds. Indicator lamps Lighted Off Blinking Remaining capacity 75% to 100% 50% to 75% 25% to 50% 0% to 25% NOTE: • Depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual capacity. ASSEMBLY CAUTION: • Hold the battery holder and the battery cartridge firmly when installing or removing battery cartridge. Failure to hold the battery holder and the battery cartridge firmly may cause them to slip off your hands and result in damage to the battery holder and battery cartridge and a personal injury. Installing or removing battery cartridge to the battery holder (Fig. 3) To install the battery cartridge (10), align the tongue on the battery cartridge with the groove in the battery holder and slip it into place. Insert it all the way until it locks in place with a little click. If you can see the red indicator (9) on the upper side of the button, it is not locked completely. Always install the battery cartridge fully until the red indicator cannot be seen. If not, it may accidentally fall out of the battery holder, causing injury to you or someone around you. Do not install the battery cartridge forcibly. If the cartridge does not slide in easily, it is not being inserted correctly. To remove the battery cartridge, slide it from the battery holder while sliding the button (8) on the front of the cartridge. 4