Makita DA4031 Owners Manual - Page 9

1 1. Spade grip 2. Wrench holder 3. Hex wrench 003042 Spade grip 2 The spade grip can be installed in any position as shown in the figure. To change the position, loosen the hex bolts (both sides) with a hex wrench and turn the spade grip to the desired position. Then tighten the hex bolts securely. After reposition the grip, return the hex wrench to the wrench 3 holder. CAUTION: • Do not fix the spade grip beyond the limits of the arrow. Be cautious that your hand is not caught in the grip. 003043 Keep the hand away from the drill chuck. They can lead to serious accidents. • Always be sure that the hex bolts (both sides) of the spade grip are tightened securely. 1. Chuck key 003054 Installing or removing drill bit To install the bit, place it in the chuck as far as it will go. Tighten the chuck by hand. Place the chuck key in each of the three holes and tighten clockwise. Be sure to tighten all three chuck holes evenly. To remove the bit, turn the chuck key counterclockwise in just 1 one hole, then loosen the chuck by hand. After using the chuck key, be sure to return to the original position. 9