Makita DA6301 Owners Manual - Page 4

FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Switch action 1. Counterclockwise 2. Switch trigger 3. Clockwise 1 2 3 Spade grip The spade grip can be installed in either of the positions as shown in the figure. To change the location of the spade grip from one position to the other, loosen the hex bolts with a wrench and turn the spade grip to another position. Then tighten the hex bolts securely. 1. Spade grip 2. Hex. bolt 1 2 003038 003019 CAUTION: • Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. • Change the direction of rotation only when the tool comes to a complete stop. Changing it before the tool stops may damage the tool. The switch is reversible, providing either clockwise or counterclockwise rotation. To start the tool, simply pull the lower part of the switch trigger for clockwise or the upper part for counterclockwise. Release the switch trigger to stop. Speed change 1. Pin 2. Slide button 1 2 003030 To change the speed, pull the pin and slide the button to the "L" position for low speed or the "H" position for high speed. If the button does not slide easily, turn the chuck slightly in either direction while sliding the button. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. 003039 Installing or removing drill bit 1. Chuck key 1 003051 To install the bit, place it in the chuck as far as it will go. Tighten the chuck by hand. Place the chuck key in each of the three holes and tighten clockwise. Be sure to tighten all three chuck holes evenly. To remove the bit, turn the chuck key counterclockwise in just one hole, then loosen the chuck by hand. OPERATION Holding tool CAUTION: • This is a powerful tool. High torque is developed and it is important that the tool should be securely held and properly braced. 4