Makita DCF301Z DCF301 Instruction Manual - Page 4

11. When disposing the battery cartridge, remove it from the tool and dispose of it in a safe place. Follow your local regulations relating to disposal of battery. 12. Use the batteries only with the products specified by Makita. Installing the batteries to non-compliant products may result in a fire, excessive heat, explosion, or leak of electrolyte. 13. If the tool is not used for a long period of time, the battery must be removed from the tool. 14. During and after use, the battery cartridge may take on heat which can cause burns or low temperature burns. Pay attention to the handling of hot battery cartridges. 15. Do not touch the terminal of the tool immediately after use as it may get hot enough to cause burns. 16. Do not allow chips, dust, or soil stuck into the terminals, holes, and grooves of the battery cartridge. It may result in poor performance or breakdown of the tool or battery cartridge. 17. Unless the tool supports the use near high-voltage electrical power lines, do not use the battery cartridge near high-voltage electrical power lines. It may result in a malfunction or breakdown of the tool or battery cartridge. 18. Keep the battery away from children. SAVE THESE INSTRUCTIONS. CAUTION: Only use genuine Makita batteries. Use of non-genuine Makita batteries, or batteries that have been altered, may result in the battery bursting causing fires, personal injury and damage. It will also void the Makita warranty for the Makita tool and charger. Tips for maintaining maximum battery life 1. Charge the battery cartridge before completely discharged. Always stop tool operation and charge the battery cartridge when you notice less tool power. 2. Never recharge a fully charged battery cartridge. Overcharging shortens the battery service life. 3. Charge the battery cartridge with room temperature at 10 °C - 40 °C (50 °F - 104 °F). Let a hot battery cartridge cool down before charging it. 4. When not using the battery cartridge, remove it from the tool or the charger. 5. Charge the battery cartridge if you do not use it for a long period (more than six months). SPECIFICATIONS This fan is equipped with 3-speed control, fan head oscillation, and auto-off timer functions. Power supply can be with Makita battery cartridge or AC adaptor. Model: DCF301 Rated voltage D.C. 14.4 V / 18 V AC adaptor Input 100 - 240 V, 50 / 60 Hz, 1.2 A max Output 12 V, 3.5 A Dimensions (L x W x H) 261 mm x 439 mm x 602 mm ( 10-1/4" x 17-1/4" x 23-3/4" ) Net weight (without battery cartridge) 3.8 kg (8.4 lbs) • Due to our continuing program of research and development, the specifications herein are subject to change without notice. • Specifications may differ from country to country. Applicable battery cartridge and charger Battery cartridge D.C.14.4 V Model BL1430B D.C.18 V Model BL1815N / BL1820B / BL1830 / BL1830B / BL1840B / BL1850B / BL1860B Charger DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF / DC18SH • Some of the battery cartridges and chargers listed above may not be available depending on your region of residence. WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridges and chargers may cause injury and/or fire. Battery running time Following table refers to some of battery cartridges from Makita. The estimated running time of full charged battery is shown: BL1860B Battery cartridge High 215 min Wind speed Medium 430 min Low 850 min 4 ENGLISH