Makita DF012DSE DF012D Instruction Manual - Page 7

Lighting up the front lamp CAUTION: Do not look in the light or see the source of light directly. To turn on the light, slide the lamp switch to the A position. To turn off the light, slide the lamp switch to B position. Even if you leave the lamp on, the light will automatically turn off after 5 minutes. 1 B A 2 ► 1 . Lamp switch 2. Lamp NOTE: The lamp signals by flickering during use when the battery power is almost used up. At this time, recharge the battery or replace the battery with a fully charged one. ASSEMBLY CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing driver bit/ socket bit Optional accessory 1 2 ► 1 . Driver bit 2. Sleeve To install the driver bit, pull the sleeve in the direction of the arrow and insert the driver bit into the sleeve as far as it will go. Then release the sleeve to secure the driver bit. To remove the driver bit, pull the sleeve in the direction of the arrow and pull the driver bit out. NOTE: If the driver bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the driver bit will not be secured. In this case, try re-inserting the bit according to the instructions above. NOTE: After inserting the driver bit, make sure that it is firmly secured. If it comes out, do not use it. OPERATION CAUTION: When bending the tool to use in the pistol shape or straightening to use in the straight shape, do not hold the bendable part of the tool. Failure to do so may cause your hand and fingers to be pinched and injured by this part. The tool can be used in two ways; a straight shape and a pistol shape which are selectable according to the conditions of workplace and screwdriving. 12 mm (15/32") 9 mm (3/8") Use only the driver bit/socket bit shown in the figure. Do not use any other driver bit/socket bit. 7 ENGLISH