Makita DML810 DML810 Instruction Manual - Page 8

Appliance / battery protection system The appliance is equipped with the protection system. This system automatically cuts off power to extend appliance and battery life. The appliance will automatically stop during operation if the appliance or battery is placed under one of the following conditions. Overload protection When the appliance is operated in a manner that causes it to draw an abnormally high current, the appliance automatically stops without any indication. In this situation, remove and install the battery cartridge when using with DC power, or push the breaker restart button when using AC power. Then turn the appliance on to restart. Hole for padlock For anti-theft of battery cartridges, hole for padlock is provided. 1 ► 1 . Hole for padlock OPERATION 1 ► 1 . Breaker restart button Overdischarge protection When the battery capacity becomes low, the LED lights go out except a part of LEDs as illustrated. Then approximately five to ten minutes later, the system automatically cuts off power. In this situation, remove the battery cartridge from the appliance and charge it. CAUTION: This appliance is intended for commercial use. Do not use the appliance for household purpose. Turning on / off the appliance Press the power switch button to turn on the appliance. Press the power switch button again to turn off the appliance. 1 ► 1 . Power switch button NOTE: The appliance turns on at the same mode as the last setting. 8 ENGLISH