Makita DP4002 Owners Manual - Page 10
Operation
View all Makita DP4002 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
OPERATION Holding against a stud 003076 1 2 1. Reaction 2. Reverse 3. Forward 1 3 Holding against a floor 003077 Holding tool When drilling a large hole with a hole saw, etc., the side grip (auxiliary handle) should be used as a brace to maintain safe control of the tool. Grasp the rear handle and the front grip firmly when starting or stopping the tool, since there is an initial and final reaction. When drilling action is forward (clockwise), the tool should be braced to prevent a counterclockwise reaction if the bit should bind. When reversing, brace the tool to prevent a clockwise reaction. If the bit must be removed from a partially drilled hole, be sure the tool is properly braced before reversing. 1 2 1. Forward 2. Reaction 10 Drilling operation Drilling in wood When drilling in wood, the best results are obtained with wood drills equipped with a guide screw. The guide screw makes drilling easier by pulling the bit into the workpiece. Drilling in metal To prevent the bit from slipping when starting a hole, make an indentation with a center-punch and hammer at the point to be drilled. Place the point of the bit in the indentation and start drilling. Use a cutting lubricant when drilling metals. The exceptions are iron and brass which should be drilled dry. CAUTION: • Pressing excessively on the tool will not speed up the drilling. In fact, this excessive pressure will only serve to damage the tip of your bit, decrease the tool performance and shorten the service life of the tool.