Makita EB7650WH Instruction Manual - Page 12
Stopping, For tube throttle model, For hip throttle model
View all Makita EB7650WH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
NOTE: ● The engine may be damaged if the choke lever is moved further beyond the "CLOSE" position. ● If the engine fires and stops, return this lever to the "OPEN" position and pull the starter handle several times to start the engine again. ● If the operator keeps pulling the starter handle several times with the choke lever left in the "CLOSE" position, the engine may be difficult to start because of flooding of the fuel. ● In case of flooding of the fuel, remove the spark plug and pull the handle several times rapidly to discharge any excess fuel. Dry the spark plug electrode. ● When the throttle valve (1) does not return to a position in contact with the idling adjusting screw (2) even if the throttle lever is set to the low speed, correct the control cable (3) catching state to ensure proper return of the valve. 2) When the engine is warm (warm start) (1) Put the engine on a flat surface. (2) Push the primer pump several times. (3) Make sure that the choke lever is open. (4) Stump the pedal with your right foot, and hold the top of the unit with left hand to prevent the engine from moving. (5) Pull slowly the starter handle till feeling compression. Then pull it strongly. (6) When the engine is difficult to start, open the throttle valve by about 1/3. 2. Stopping For tube throttle model Release the throttle trigger (2) and then set the stop control lever (1) to "O" position. For hip throttle model Set the throttle lever (1) to the low speed position to reduce the engine speed. Then set the stop switch (2) to "O" position. (1) (2) EB7650TH (1) (2) (3) (1) (2) O O EB7650WH 12