Makita HK1820 Instruction Manual - Page 5
Installing or removing the bit
View all Makita HK1820 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Installing or removing the bit 1 2 Bit angle 1 ► 1 . Bit 2. Chuck cover Clean the bit shank before installing the bit. Insert the bit into the tool. Turn the bit and push it in until it engages. ► 1 . Change ring 1 1 ► 1 . Chuck cover If the bit cannot be pushed in, remove the bit. Pull the chuck cover down a couple of times. Then insert the bit again. Turn the bit and push it in until it engages. After installing, always make sure that the bit is securely held in place by trying to pull it out. To remove the bit, pull the chuck cover down all the way and pull the bit out. ► 1 . Change ring The bit can be secured at 12 different angles. To change the bit angle, slide the change ring forward, then turn the change ring to change the bit angle. At the desired angle, slide the change ring back to the original position. The bit will be secured in place. Hook 1 2 3 ► 1 . Hook 2. Power supply cord 3. Extension cord When connecting the power supply cord to an extension cord, use the hook so that the plug of power supply cord cannot be disconnected from the connector of extension cord. Set it on the extension cord 10 cm - 20 cm (4" - 8") away from the connector of the extension cord. 5 ENGLISH