Makita HM0871C HM0871C Instruction Manual - Page 5
Assembly - brushes
View all Makita HM0871C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Indicator lamp Installing or removing the bit 1 1 2 2 ► 1 . Power-ON indicator lamp (green) 2. Service indicator lamp (red) The green power-ON indicator lamp lights up when the tool is plugged. If the indicator lamp does not light up, the mains cord or the controller may be malfunction. The indicator lamp is lit but the tool does not start even if the tool is switched on, the carbon brushes may be worn out, or the controller, the motor or the ON/OFF switch may be malfunction. The red service indicator lamp flickers up when the carbon brushes are nearly worn out to indicate that the tool needs servicing. After approx. 8 hours of use, the motor will automatically be shut off. ► 1 . Bit shank 2. Bit grease Clean the bit shank and apply bit grease before installing the bit. Insert the bit into the tool. Turn the bit and push it in until it engages. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Side handle (auxiliary handle) 1 ► 1 . Releasing cover If the bit cannot be pushed in, remove the bit. Pull the releasing cover down a couple of times. Then insert the bit again. Turn the bit and push it in until it engages. 1 ► 1 . Side grip (auxiliary handle) The side grip swings around to either side, allowing easy handling of the tool in any position. Loosen the side grip by turning it counterclockwise, swing it to the desired position and then tighten it by turning clockwise. After installing, always make sure that the bit is securely held in place by trying to pull it out. 5 ENGLISH