Makita HM1100C Owners Manual - Page 6
Functional, Description, Assembly
View all Makita HM1100C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. 1 1. Switch lever 002888 Switch action CAUTION: • Before plugging in the tool, always check to see that the tool is switched off. • Switch can be locked in "ON" position for ease of operator comfort during extended use. Apply caution when locking tool in "ON" position and maintain firm grasp on tool. To start the tool, push the switch lever on the left side of the tool. To stop the tool, push the switch lever on the right side of the tool. 1. Adjusting dial 002895 Speed change The blows per minute can be adjusted just by turning the adjusting dial. This can be done even while the tool is run- ning. The dial is marked 1 (lowest speed) to 5 (full speed). Refer to the table below for the relationship between the 1 number settings on the adjusting dial and the blows per minute. Number on adjusting dial 5 4 3 2 1 Blows per minute 2,650 2,350 1,950 1,550 1,300 ASSEMBLY 6 CAUTION: • The speed adjusting dial can be turned only as far as 5 and back to 1. Do not force it past 5 or 1, or the speed adjusting function may no longer work. CAUTION: • Always be sure that the tool is switched off and unplugged before carrying out any work on the tool.