Makita HM1213C HM1213C Instruction Manual - Page 4

Symbols The followings show the symbols used for tool. volts Speed change amperes hertz alternating current Class II Construction revolutions or reciprocation per minute number of blow FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Switch action 1 ► 1 . Adjusting dial The blows per minute can be adjusted just by turning the adjusting dial. This can be done even while the tool is running. The dial is marked 1 (lowest speed) to 5 (full speed). Refer to the table below for the relationship between the number settings on the adjusting dial and the blows per minute. Number on adjusting dial 5 4 3 2 1 Blows per minute 1,900 1,700 1,450 1,200 950 CAUTION: • The speed adjusting dial can be turned only as far as 5 and back to 1. Do not force it past 5 or 1, or the speed adjusting function may no longer work. OFF ON 1 ► 1 . Switch lever For Model HM1213C only NOTE: • Blows at no load per minute becomes smaller than those on load in order to reduce vibration under no load, but this does not show trouble. Once operation starts with a bit against concrete, blows per minute increase and get to the numbers as shown in the table. When temperature is low and there is less fluidity in grease, the tool may not have this function even with the motor rotating. CAUTION: • Before plugging in the tool, always check to see that the tool is switched off. • Switch can be locked in "ON" position for ease of operator comfort during extended use. Apply caution when locking tool in "ON" position and maintain firm grasp on tool. To start the tool, push the switch lever "ON (I)" on the left side of the tool. To stop the tool, push the switch lever "OFF (O)" on the right side of the tool. 4 ENGLISH