Makita HM1317CB Owners Manual - Page 6
Operation, Maintenance
View all Makita HM1317CB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
CAUTION: • Always assure that the bit is securely retained by attempting to pull the bit out of the tool holder after completing the above procedure. (2) For bits without a collar operations. Turn the tool on and apply slight pressure on the tool so that the tool will not bounce around, uncontrolled. Pressing very hard on the tool will not increase the efficiency. MAINTENANCE 1 2 3 4 5 1. Bit 2. Tool retainer 3. Tool holder 4. When the bit is inserted 5. When the bit is retained 010294 Pivot the tool retainer forward and slightly downward. With the notched portion of the bit facing the tool retainer shaft, insert the bit into the tool holder as far as it will go. Then pivot the tool retainer further downward toward the barrel to securely retain the bit. CAUTION: • Always assure that the bit is securely retained by attempting to pull the bit out of the tool holder after completing the above procedure. • The bit without a collar cannot be retained by the method shown in Fig.(1). To remove the bit, follow the installation procedure in reverse. OPERATION Chipping/Scaling/Demolition CAUTION: • Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. Lubrication CAUTION: • This servicing should be performed by Makita Authorized or Factory Service Centers only. This tool requires no hourly or daily lubrication because it has a grease-packed lubrication system. However, it is recommended to periodically replace the grease for longer tool life. First, switch off and unplug the tool. For model HM1307CB only 1. Rear cover 1 2. Hex wrench 2 010289 Remove the six screws using a hex wrench and remove the rear cover. 1. Crank cap 1 010290 Pull out the crank cap in the direction of arrow and remove it. 010288 Always use the side grip (auxiliary handle) and firmly hold the tool by both side grip and switch handle during 6