Makita HM1810X3 Owners Manual - Page 4
Symbols, Functional Description, Assembly
View all Makita HM1810X3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
SYMBOLS USD293-1 The followings show the symbols used for tool. V volts A amperes Hz hertz alternating or direct current Class II Construction .../min revolutions or reciprocation per minute number of blow FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Switch action 006199 1. Switch lever 1 CAUTION: • Before plugging in the tool, always check to see that the switch lever actuates properly and returns to the "OFF" position when released. To start the tool, simply squeeze the switch lever. Release the switch lever to stop. Indicator lamp 006200 1. Indicator lamp The green power-ON indicator lamp lights up when the tool is plugged to the mains. If the indicator lamp is lit but the tool does not start even if the tool is switched ON, the carbon brushes may be worn out, or the motor or the switch may be defective. If the indicator lamp does not light up, the mains cord or the indicator lamp may be defective. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Installing or removing the bit 002928 1. Bit with collar 1 2. Bit without coller 2 This tool accepts bits either with or without a collar on its shank. To install the bit, follow either procedure (1) or (2) described below. (1) For bits with a collar 1 2 3 006202 Fig.1 1. Bit 2. Tool retainer 3. Tool holder 4. When the bit is inserted 5. When the bit is retained 4 5 Pivot the tool retainer back and slightly downward. Insert the bit into the tool holder as far as it will go. To securely retain the bit, return the tool retainer to its original position. CAUTION: • Always assure that the bit is securely retained by attempting to pull the bit out of the tool holder after completing the above procedure. 1 4