Makita LCT208W Owners Manual - Page 8
Assembly
View all Makita LCT208W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Switch action 1 1. Lock-off lever 2. Switch trigger 2 011329 CAUTION: • Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. • Do not pull the switch trigger hard without pressing the lock-off lever. This can cause switch breakage. To prevent the switch trigger from being accidentally pulled, a lock-off lever is provided. To start the tool, slide the lock-off lever and pull the switch trigger. Release the switch trigger to stop. WARNING: • For your safety, this tool is equipped with lock-off lever which prevents the tool from unintended starting. NEVER use the tool if it runs when you simply pull the switch trigger without pressing the lock-off lever. Return tool a MAKITA service center for proper repairs BEFORE further usage. • NEVER tape down or defeat purpose and function of lock-off lever. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Removing or installing saw blade 1 1. Shaft lock 2. Hex wrench • Use only the Makita wrench to install or remove the blade. To remove the blade, press the shaft lock fully so that the blade cannot revolve and use the wrench to loosen the hex bolt counterclockwise. Then remove the hex bolt, outer flange and blade. 3 2 1 1. Hex bolt 2. Outer flange 3. Saw blade 4. Inner flange 4 011331 To install the blade, follow the removal procedure in reverse. BE SURE TO TIGHTEN THE HEX BOLT CLOCKWISE SECURELY. 1 2 3 5 6 4 1. Hex bolt 2. Protrusion 3. Outer flange 4. Saw blade 5. Inner flange 6. Protrusion (bigger side) 011386 NOTE: • If a inner flange is removed by chance, install the inner flange so that its protrusion (bigger side) faces inside as shown in the figure. When changing blade, make sure to also clean upper and lower blade guards of accumulated sawdust. Such efforts do not, however, replace the need to check lower guard operation before each use. Hex wrench storage 1. Hex wrench 2 011330 CAUTION: • Be sure the blade is installed with teeth pointing up at the front of the tool. 1 011332 When not in use, store the hex wrench as shown in the figure to keep it from being lost. 8