Makita LS1216LX Owners Manual - Page 17
Measuring, at the, back of the workpiece, In the case of left bevel cut, Example, In the case
View all Makita LS1216LX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Measuring Measure the wall length and adjust workpiece on table to cut wall contact edge to desired length. Always make sure that cut workpiece length at the back of the workpiece is the same as wall length. Adjust cut length for angle of cut. Always use several pieces for test cuts to check the saw angles. When cutting crown and cove moldings, set the bevel angle and miter angle as indicated in the table (A) and position the moldings on the top surface of the saw base as indicated in the table (B). In the case of left bevel cut Table (A) Molding Bevel angle position in Fig. A 52/38° type 45° type For inside (1) corner (2) For outside (3) corner (4) 006361 Left 33.9° Left 30° Miter angle 52/38° type 45° type Right 31.6° Right 35.3° Left 31.6° Left 35.3° Right 31.6° Right 35.3° Table (B) Molding position in Fig. A Molding edge against guide fence Finished piece For inside (1) Ceiling contact edge should be against guide fence. Finished piece will be on the corner Left side of (2) blade. Wall contact edge should be For outside against guide fence. (3) Finished piece will be on the corner Ceiling contact edge should Right side of (4) be against guide fence. blade. 006362 In the case of right bevel cut Table (A) Molding Bevel angle position in Fig. A 52/38° type 45° type For inside (1) corner (2) Right 33.9° Right 30° For outside (3) corner (4) 006363 Miter angle 52/38° type 45° type Right 31.6° Right 35.3° Left 31.6° Left 35.3° Right 31.6° Right 35.3° Table (B) Molding position in Fig. A Molding edge against guide fence Finished piece For inside (1) Wall contact edge should be Finished piece against guide fence. will be on the corner Right side of (2) blade. Ceiling contact edge should For outside be against guide fence. (3) Finished piece will be on the corner (4) Wall contact edge should be Left side of against guide fence. blade. 006364 Example: In the case of cutting 52/38° type crown molding for position (1) in Fig. A: • Tilt and secure bevel angle setting to 33.9° RIGHT. • Adjust and secure miter angle setting to 31.6° RIGHT. • Lay crown molding with its broad back (hidden) surface down on the turn base with its WALL CONTACT EDGE against the guide fence on the saw. • The finished piece to be used will always be on the RIGHT side of the blade after the cut has been made. Example: In the case of cutting 52/38° type crown molding for position (1) in Fig. A: • Tilt and secure bevel angle setting to 33.9° LEFT. • Adjust and secure miter angle setting to 31.6° RIGHT. • Lay crown molding with its broad back (hidden) surface down on the turn base with its CEILING CONTACT EDGE against the guide fence on the saw. • The finished piece to be used will always be on the LEFT side of the blade after the cut has been made. 17