Makita LS1221 Owners Manual - Page 9
Maintaining maximum cutting capacity, Adjusting the miter angle - 12
View all Makita LS1221 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
1 1. Adjusting bolt 2 1 001835 Maintaining maximum cutting capacity This tool is factory adjusted to provide the maximum cutting capacity for a 305 mm (12") saw blade. When installing a new blade, always check the lower limit position of the blade and if necessary, adjust it as follows: First, unplug the tool. Lower the handle completely. Use the socket wrench to turn the adjusting bolt until the periphery of the blade extends slightly below the top surface of the turn base at the point where the front face of the guide fence 001540 meets the top surface of the turn base. With the tool unplugged, rotate the blade by hand while holding the handle all the way down to be sure that the blade does not contact any part of the lower base. Re-adjust slightly, if necessary. 3 1. Top surface ot turn base 2. Periphery of blade 3. Guide fence CAUTION: • After installing a new blade, always be sure that the blade does not contact any part of the lower base when the handle is lowered completely. Always do this with the tool unplugged. 1 2 1. Miter scale 2. Pointer 3. Grip 4. Lock lever 001836 4 3 Adjusting the miter angle Loosen the grip by turning counterclockwise. Turn the turn base while pressing down the lock lever. When you have moved the grip to the position where the pointer points to the desired angle on the miter scale, securely tighten the grip clockwise. CAUTION: • When turning the turn base, be sure to raise the handle fully. • After changing the miter angle, always secure the turn base by tightening the grip firmly. 9