Makita ML702 Owners Manual - Page 4
Operating Instructions, Maintenance - flashlight
View all Makita ML702 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
. OPERATING INSTRUCTIONS Charging For ML702, ML901 and ML902 (Fig. 1) Charge the battery cartridge with the Makita charger before use. To remove the battery cartridge, pull out the set plate on the torch/flashlight and grasp both sides of the cartridge while withdrawing it from the torch/flashlight. After charging, insert the battery cartridge into the torch/flashlight and snap the set plate back into place. For ML903 (Fig. 2) Charge the battery cartridge with the Makita charger before use. To remove the battery cartridge, withdraw it from the torch/flashlight while pressing the buttons on both sides of the cartridge. After charging, insert the battery cartridge into the torch/flashlight all the way until it locks in place with a little click. NOTE: Battery cartridges 9100, 9101, 9101A, 9102, 9102A can be used on ML903 if you install the set plate. Install - the set plate on ML903 with the screw provided as shown in Fig. 3. The following tables indicate the charging time and operating time on a single charge. ML702 1 Battery cartridge Operating time Battery 9100/9120 Battery Battery 9101/9101A 9102/9102N9122 Battery 9133 Approx. 120 min. Approx. 170 min. Approx. 200 min. Approx. 220 min. . ML902 Battery cartridge Operating time Battery 9000 Battery 9001 Battery 9002 Battery 9033 Approx. 120 min. Approx. 170 min. Approx. 200 min. Approx. 220 min. Head angle (Fig. 4) The head angle can be adjusted in four stages. Adjust as desired. Replacing bulb (Fig. 5 & 6) CAUTION: The bulb is very hot immediately after operation. Wait until the bulb cools off before attempting to replace it. First, turn the ring counterclockwise and remove the reflector. Remove the bulb holder by turning it counterclockwise. Then replace the bulb. . MAINTENANCE To maintain product safety and reliability, repairs, maintenance or adjustment should be carried out by Makita Authorized Service Center. 4