Makita XAD05T XAD05 XAD06 Instruction Manual - Page 8
Installing or removing drill bit
View all Makita XAD05T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Installing or removing drill bit For model XAD05 To install the drill bit, place it in the chuck as far as it will go. Tighten the chuck by hand. Place the chuck key in each of the three holes and tighten clockwise. Be sure to tighten all three chuck holes evenly. To remove the drill bit, turn the chuck key counterclockwise in just one hole, then loosen the chuck by hand. To install the drill bit, pull the sleeve in the direction of the arrow and insert the drill bit into the sleeve as far as it will go. Then release the sleeve to secure the drill bit. To remove the drill bit, pull the sleeve in the direction of the arrow and pull the drill bit out. 1 2 1 ► 1 . Chuck key After use, return the chuck key to the key holder on the tool as illustrated. 1 ► 1 . Key holder For model XAD06 Use only the drill bit designed with dimensions shown in the figure. A=11.2 mm (7/16″) ► 1 . Drill bit 2. Sleeve NOTE: If the drill bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the drill bit will not be secured. In this case, try re-inserting the drill bit according to the instructions above. NOTE: After inserting the drill bit, make sure that it is firmly secured. If it comes out, do not use it. Hook CAUTION: Always remove the battery when hanging the tool with the hook. CAUTION: Never hook the tool at high location or on potentially unstable surface. The hook is convenient for temporarily hanging the tool. To use the hook, simply lift up hook until it snaps into the open position. When not in use, always lower hook until it snaps into the closed position. 1 A ► 1 . Hook 8 ENGLISH