Makita XDT15ZB XDT15 Instruction Manual - Page 9
Maintenance - parts
View all Makita XDT15ZB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Standard bolt N•m (ft•lbs) 120 (87) 100 (72) 80 (58) 2 60 (43) 40 (29) 20 (14) M14(9/16") M12(1/2") M14(9/16") 3 M10(3/8") M12(1/2") M8(5/16") M10(3/8") M8(5/16") 0 1.0 2.0 3.0 1 1. Fastening time (second) 2. Fastening torque 3. Proper fastening torque corresponding to each bolt diameter High tensile bolt N•m (ft•lbs) 120 (87) 100 (72) 80 (58) 2 60 (43) 40 (29) 20 (14) M12(1/2") M12(1/2") M10(3/8") M8(5/16") 3 M10(3/8") M8(5/16") 0 1.0 2.0 3.0 1 1. Fastening time (second) 2. Fastening torque 3. Proper fastening torque corresponding to each bolt diameter Hold the tool firmly and place the point of the driver bit in the screw head. Apply forward pressure to the tool to the extent that the bit will not slip off the screw and turn the tool on to start operation. NOTICE: If you use a spare battery to continue the operation, rest the tool at least 15 min. NOTE: Use the proper bit for the head of the screw/ bolt that you wish to use. NOTE: When fastening M8 or smaller screw, choose a proper impact force and carefully adjust pressure on the switch trigger so that the screw is not damaged. NOTE: Hold the tool pointed straight at the screw. NOTE: If the impact force is too strong or you tighten the screw for a time longer than shown in the figures, the screw or the point of the driver bit may be overstressed, stripped, damaged, etc. Before starting your job, always perform a test operation to determine the proper fastening time for your screw. The fastening torque is affected by a wide variety of factors including the following. After fastening, always check the torque with a torque wrench. 1. When the battery cartridge is discharged almost completely, voltage will drop and the fastening torque will be reduced. 2. Driver bit or socket bit Failure to use the correct size driver bit or socket bit will cause a reduction in the fastening torque. 3. Bolt • Even though the torque coefficient and the class of bolt are the same, the proper fastening torque will differ according to the diameter of bolt. • Even though the diameters of bolts are the same, the proper fastening torque will differ according to the torque coefficient, the class of bolt and the bolt length. 4. The manner of holding the tool or the material of driving position to be fastened will affect the torque. 5. Operating the tool at low speed will cause a reduction in the fastening torque. MAINTENANCE CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance. NOTICE: Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result. To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. 9 ENGLISH