Makita XDT16R XDT16 Instruction Manual - Page 11

Quick mode-switching function What you can do with the quick modeswitching function The quick mode-switching function saves the time for changing the application mode of the tool. You can switch to your desired application mode by just pressing the quick mode-switching button. It is helpful when doing a repetitive work which requires to switch between two application modes alternately. EXAMPLE If you have a work to use T mode and max impact force, register the max impact force for quick mode-switching function. Once register it, you can switch to the max impact force from T mode by just one click of the quick mode-switching button. Also, you can return to T mode by pressing the quick mode-switching button again. Even if the tool is in other application mode than T mode, pressing the quick mode-switching button changes to max impact force. It is convenient for you to register a application mode that you frequently use. You can choose one of following application modes for quick mode-switching function: Impact force • Max • Hard • Medium • Soft Assist type • Wood mode • Bolt mode • T mode (1) • T mode (2) Registering application mode To use the quick mode-switching function, register your desired application mode to the tool beforehand. 1. With the button or , choose your desired application mode. 2. Press and hold the button and the quick mode-switching button at the same time until the customize lamp and the lamp of desired application mode blinks. Using the quick mode-switching function When the tool is in the mode that is not registered, press the quick mode-switching button to switch to the registered application mode. The tool switches between the registered application mode and last application mode every time you press the quick mode-switching button. The front lamps on both sides will flash once when switching to the registered application mode. NOTE: The customize lamp will light up when the application mode registered to the tool is chose. Cancelling the quick mode-switching function Press and hold the button and quick mode-switching button at the same time until the customize lamp and all impact force grade lamps blink. NOTE: After cancelling the quick mode-switching function, the quick mode-switching button works for changing the impact force. ASSEMBLY CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing driver bit/ socket bit 12 mm (15/32") 9 mm (3/8") Use only the driver bit/socket bit shown in the figure. Do not use any other driver bit/socket bit. 1 2 1 2 ► 1 . Quick mode-switching button 2. Customize lamp NOTE: You can overwrite the current application mode with new one by performing the procedure above. ► 1 . Driver bit 2. Sleeve 11 ENGLISH