Makita XGC01Z Makita XGC01Z Instruction Manual - Page 8
Installing holder, Installing cartridge, Installing film type pack
View all Makita XGC01Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Installing holder Insert the cartridge into the holder as illustrated. Push the rod gently until the piston touches the bottom of the cartridge. To remove the cartridge, pull the rod backwards until it stops, then lift out the cartridge. Installing the cartridge into the long holder (600ml(36.6cu.in) or big holder (800ml(48.8cu.in)) 013562 Hold the bottom of the holder and the holder joint, then turn the holder clockwise. Tighten it firmly until it stops. Make sure the holder is tightened firmly. Otherwise the tool may be damaged. To remove the holder, turn it counter clockwise. NOTE: • You can rotate the holder in accordance with required situations to facilitate the operation. • The short holder (300ml(18.3cu.in)) and big holder (800ml(48.8cu.in)) are intended for the cartridges only. Use only piston A with short holder (300ml(18.3cu.in)). Use only piston D with big holder (800ml(48.8cu.in)) Do not use them with film type packs or direct filling. Also use appropriate rod in accordance with the holder type. Installing cartridge NOTICE: • Make sure the piston A is attached to the rod. Do not use other type of piston for cartridge. Installing the cartridge into the short holder (300ml(18.3cu.in)) 1. Rod handle 1 013566 Pull the rod handle backwards slowly until it stops. 1. Holder cap 2. Rod handle 2 1 013572 Remove the holder cap from the holder. Pull the rod handle backwards slowly until it stops. 1. Holder cap 1 013571 Insert the cartridge into the holder. Attach the holder cap. Make sure it is tightened firmly. Push the rod gently until the piston touches the bottom of the cartridge. To remove the cartridge, remove the holder cap, then take out the cartridge. NOTICE: • Always check the cartridge for puncture or damage before installing. Do not use damaged cartridge, otherwise the tool may be damaged. • When using a partially used cartridge, remove any adhered material on the cartridge. Installing film type pack NOTICE: • Make sure the piston B is attached to the rod. Do not use other type of piston for film type pack. • Film type pack can be installed in the long holder (600ml(36.6cu.in)) only. Remove the holder cap, the nozzle and the rubber ring from the holder. Pull the rod handle backwards slowly until it stops. 013567 8