Makita XPH16Z Instruction Manual 1 - Page 8

Adjusting ring You can select the action mode and adjust the fastening torque with the adjusting ring. Selecting the action mode 1 2 3 Fig.7 ► 1 . Adjusting ring 2. Mark 3. Arrow Adjusting the fastening torque This tool has three action modes. Drilling mode (rotation only) Hammer drilling mode (rotation with hammering) 1 - 21 Screwdriving mode (rotation with clutch) Select the mode suitable for your work. Turn the adjusting ring and align the mark that you select with the arrow on the tool body. NOTICE: Always set the ring correctly to your desired mode mark. If you operate the tool with the ring positioned halfway between the mode marks, the tool may be damaged. NOTICE: Do not change the action mode while tool is rotating. NOTICE: If it is difficult to slide the adjusting ring, switch on and run the tool for a second, then stop the tool and slide the adjusting ring to your desired position again. 1 2 3 Fig.8 ► 1 . Adjusting ring 2. Mark (1 - 21 graduation) 3. Arrow The fastening torque can be adjusted in 21 levels by turning the adjusting ring. Align the graduations with the arrow on the tool body. You can get the minimum fastening torque at 1 and maximum torque at 21. Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which torque level is required for a particular application. Graduation 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 Machine screw M4 M5 M6 Wood Soft wood - ø3.5 x 22 ø4.1x 38 - screw (e.g. pine) Hard wood - (e.g. lauan) ø3.5 x 22 ø4.1x 38 - NOTE: The adjusting ring does not lock when the arrow is positioned only halfway between the graduations. 8 ENGLISH