Makita XPK01 XPK01Z Instruction Manual - Page 7
Installing conventional planer blade, optional accessory
View all Makita XPK01 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
1 6 1. Mini planer blade 5 2. Groove 3. Set plate 4. Hex. flange 4 head bolts 7 3 5. Drum cover 6. Drum 2 7. Adjusting plate 002566 6. Set the drum cover over the adjusting plate/set plate and screw in the three hex flange head bolts so that a gap exists between the drum and the set plate to slide the mini planer blade into position. The blade will be positioned by the planer blade locating lugs on the set plate. 7. The blade's lengthwise adjustment will need to be manually positioned so that the blade ends are clear and equidistant from the housing on one side and the metal bracket on the other. 8. Tighten the three hex flange head bolts (with the socket wrench provided) and hand rotate the drum to check clearances between the blade ends and the tool body. 9. Check the three hex flange head bolts for final tightness. 10. Repeat procedures 1 - 9 for other blade. Installing conventional planer blade (optional accessory) To install the blades, first clean out all chips or foreign matter adhering to the drum or blades. Use blades of the same dimensions and weight, or drum oscillation/vibration will result, causing poor planing action and, eventually, tool breakdown. 1 1. Bolts 2. Drum 3. Planer blade 4. Drum cover 5. Adjusting plate 2 3 4 5 002555 Place the blade on the gauge base so that the blade edge is perfectly flush with the inside edge of the gauge plate. Place the adjusting plate on the blade, then simply press in the heel of the adjusting plate flush with the back side of the gauge base and tighten two screws on the adjusting plate. Now slip the heel of the adjusting plate into the drum groove, then fit the drum cover on it. Tighten all the installation bolts evenly and alternately with the socket wrench. Repeat the above procedures for the other blade. 2 3 4 5 6 7 002556 7 1. Inside edge of gauge plate 2. Blade edge 3. Planer blade 4. Adjusting plate 1 5. Screws 6. Heel 8 7. Back side of gauge base 8. Gauge plate 9 9. Gauge base