Makita XRH03Z XRH03Z Instruction Manual - Page 7

ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Side grip (auxiliary handle) 1 5 6 2 4 1. Grip base 2. Teeth 3. Side grip 4. Protrusion 5. Loosen 6. Tighten 3 008830 CAUTION: • Always use the side grip to ensure operating safety. Install the side grip so that the teeth on the grip fit in between the protrusions on the tool barrel. Then tighten the grip by turning clockwise at the desired position. It may be swung 360° so as to be secured at any position. Bit grease Coat the bit shank head beforehand with a small amount of bit grease (about 0.5 -1 g; 0.02 - 0.04 oz.). This chuck lubrication assures smooth action and longer service life. Installing or removing the bit Clean the bit shank and apply bit grease before installing the bit. 1. Bit shank 1 2. Bit grease If the bit cannot be pushed in, remove the bit. Pull the chuck cover down a couple of times. Then insert the bit again. Turn the bit and push it in until it engages. After installing, always make sure that the bit is securely held in place by trying to pull it out. To remove the bit, pull the chuck cover down all the way and pull the bit out. 1. Bit 2. Chuck cover 1 2 001298 Bit angle (when chipping, scaling or demolishing) 1. Action mode changing knob 2. O symbol 2 1 007578 The bit can be secured at the desired angle. To change the bit angle, depress the lock button and rotate the action mode changing knob to the O symbol. Turn the bit to the desired angle. Depress the lock button and rotate the action mode changing knob to the symbol. Then make sure that the bit is securely held in place by turning it slightly. 2 001296 Insert the bit into the tool. Turn the bit and push it in until it engages. 1. Bit 2. Chuck cover 1 2 007579 007342 7