Makita XRJ01 Owners Manual - Page 7

NOTE: • If you remove the saw blade without rotating the blade clamp sleeve fully, the sleeve may not be fixed. In this case, rotate the blade clamp sleeve fully, then make the sleeve fixed at the released position. For Model XRJ04 1 3 4 1 1. Hex wrench 2. Bolt 3. Loosen 4. Tighten 2 2 014045 1 3 4 1. Saw blade 2. Blade clamp 3. Hole for recipro saw blade 4. Hole for jig saw blade 014047 2 3 4 1. Recipro saw blade 2. Hex wrench 3. Hole for recipro saw blade 4. Blade clamp 014048 To install the saw blade, loosen the bolt by hex wrench. When installing a recipro saw blade, press the bolt with the hex wrench to open the slot during inserting the blade. 014086 You can use both jig saw blades (B type) and recipro saw blades according to your work. Insert the saw blade straight into the blade clamp and tighten it by hex wrench. Pull the saw blade lightly to make sure that the saw blade does not fall off during operation. To remove the saw blade, follow the installation procedure in reverse. Hex wrench storage 1. Hex wrench 1 2. Protrusion 2 014202 When not in use, store the hex wrench as shown in the figure to keep it from being lost. 7