Makita XRU12SM1 XRU11 Instruction Manual - Page 14

1 2 3 ► 1 . Spool 2. Housing 3. Eyelet 5. Align the protrusion on the underside of the cover with the slots of the eyelets. Then push the cover firmly onto the housing to secure it. To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. TROUBLESHOOTING Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual, do not attempt to dismantle the tool. Instead, ask Makita Authorized Service Centers, always using Makita replacement parts for repairs. State of abnormality Motor does not run. Probable cause (malfunction) Battery cartridge is not installed. Battery problem (under voltage) Motor stops running after a little use. The drive system does not work correctly. Battery's charge level is low. It does not reach maximum RPM. Overheating. Battery is installed improperly. Battery power is dropping. Cutting tool does not rotate: stop the machine immediately! Abnormal vibration: stop the machine immediately! Cutting tool and motor cannot stop: Remove the battery immediately! The drive system does not work correctly. Foreign object such as a branch is jammed between the guard and the nylon cutting head. The drive system does not work correctly. One end of the nylon cord has been broken. The drive system does not work correctly. Electric or electronic malfunction. Remedy Install the battery cartridge. Recharge the battery. If recharging is not effective, replace battery. Ask your local authorized service center for repair. Recharge the battery. If recharging is not effective, replace battery. Stop using of tool to allow it to cool down. Install the battery cartridge as described in this manual. Recharge the battery. If recharging is not effective, replace battery. Ask your local authorized service center for repair. Remove the foreign object. Ask your local authorized service center for repair. Tap the nylon cutting head against the ground while it is rotating to cause the cord to feed. Ask your local authorized service center for repair. Remove the battery and ask your local authorized service center for repair. 14 ENGLISH